 |
Actual product may vary from the image shown.
-
You can fully automatically ensure a constant water level in your aquarium using the water-level module (automatic level system). To float switch used is installed inside a casing protected from waves to prevent a pump switching on and off unnecessarily. In the unlikely event of the float switch failing, a timed alarm can be triggered to prevent flooding your living room. That means: if the specified level is not reached within a certain period of time, the pump will be pre-emptorily deactivated. The alarm time for this depends on the connected pump and can be easily set as the user wishes.
Technical data IKS Water-level module with sensor:
Switch hysteresis: approx. 2 mm
Up to eight control processes can be programmed
Timed alarm for maximum safety. -
Reviews for IKS Water-level module with sensor:
Write a reviewPascal G. at 01.01.2016:
I installed this water level in my tank few weeks ago and it works like a charm! It is fantastik!Very easy set up... I use it with a IKS computer and a Aquastar Vario 4 dosing pumps. I save the water in 25l jerrycan.
2 remarks:
1. the pump works at any time of day and night - the computer doesn't let you set up a time span to authorize the pump activation. I will be pleased if it was possible to set the computer to check the level only between 02:00 and 05:00 AM. So you are not disturbed by the noise during the day.
2. the computer should know when the jerrycan is almost empty and let you know (alarm or flashing). It is easily done by entering the pump debit and the volume of the jerrycan, then the computer should be able to keep a counter of the water passed in the pump... (hope this make sens).
Your question: IKS Water-level module with sensor
- Pascal G. wrote about IKS Water-level module with sensor in 2016:
I installed this water level in my tank few weeks ago and it works like a charm! It is fantastik!Very easy set up... I use it with a IKS computer and a Aquastar Vario 4 dosing pumps. I save the water in 25l jerrycan.
2 remarks:
1. the pump works at any time of day and night - the computer doesn't let you set up a time span to authorize the pump activation. I will be pleased if it was possible to set the computer to check the level only between 02:00 and 05:00 AM. So you are not disturbed by the noise during the day.
2. the computer should know when the jerrycan is almost empty and let you know (alarm or flashing). It is easily done by entering the pump debit and the volume of the jerrycan, then the computer should be able to keep a counter of the water passed in the pump... (hope this make sens).
