 |
Actual product may vary from the image shown.
-
technical Data Aqua Medic DC Runner 3.3:
transparency pump housing
0-10 V connection for external control
Pump output: up to 3000 l/h
max. pump height: 2.7 m
max. Power consumption: 25 W
Power supply pump: 24 V
Power supply transformer: 110-240 V/50-60 Hz
Connector suction side: 32 mm
Connector pressure side: 25 mm
Protection rating: IPX8
Dimensions incl. basket: 195x90x115 mm
Dimensions without basket: 145x90x115 mm
suitable for fresh and marine water
can be installed fully submerged or out of waterThe Aqua Medic DC Runner 3.3 is a powerful universal pump for use in fresh and marine water aquaria. The Aqua Medic DC Runner is a magnetically coupled current pump and have a fully encapsulated synchronous motor. All materials are salt-water resistant. The pump is operated at 24 V DC safety voltage, with the transformer included. The Aqua Medic DC Runner 3.3 is controlled via Aqua Medic DC Runner Controller which allows for running a variety of different levels. In addition to control via controller, control via app with smartphone or tablet is possible. The Aqua Medic DC Runner pump is suitable for installation under water and out of water.
Aqua Medic DC Runner Controller The included DC Runner Controller is switched between power supply and pump to adjust the output. The power can be adjusted by pressing the +/- buttons, the level is displayed by LED. If you press the button -FEED-, the output will stop for 10 minutes. There is an automatic shut off if there is no water for 2 minutes. An extension cable with 1.80 m in the length is optionally available. With this cable you can extend the cable between pump and controller.
Aqua Medic DC Runner 3.3
- for use as a circulation or current pump in salt or freshwater aquaria
- incl. controller for adjusting the water output
- control and programming via App (iTunes and Google Playstore) or manually via the controller
- 0-10 V-connection for external control
- ULTRA SILENT due to optimized control electronics
- rugged pump housing
- power-saving D/C motor 24 Volt, high efficiency
- polished ceramic shaft and bearings for quiet operation and low maintenance
- submerged and non-submerged use is possible
- for use as a circulation or current pump in salt or freshwater aquaria
- Accessories for this article:
-
Reviews for Aqua Medic DC Runner 3.3:
Write a reviewSilvan S. at 01.01.2023:
Ich habe meine zwei Aussenfilter Eheim 4+ 600 durch ein Technikbecken und der Rückförderpumpe Aqua Medic DC Runner 3.3 ersetzt, weil meine Frau nonstop beanstand, dass die Eheimfilter zu laut sind, was aber auch tatsächlich so war. In der Hoffnung, dass mit der DC Runner 3.3 Ruhe im Wohnzimmer Einzug hält, wurden wir nach dem Umbau absolut positiv überrascht. Die DC Runner 3.3 hat eine eindrückliche Laufruhe und kann sehr präzise eingestellt werden, so dass Einlauf / Rücklauf gut optimiert werden kann. Diese Rückförderpumpe arbeitet meiner Wahrnehmung nach gleich leise, wie die Speedy von Royal Exclusive zu einem absolut fairen Preis. Ich kann die DC Runner 3.3 jedem empfehlen, der die absolute Super Silent Laufruhe sucht. Jetzt ist sogar meine Frau zufrieden und ich würde diese Rückförderpumpe sofort wieder kaufen. Ein absolutes top Produkt.Marcos A. at 31.07.2022:
This a very good quality pump ,very quiet, with great performance, really happy about itgiorgos v. at 04.11.2018:
ideal for sump filters. I use it in a 1000-liter aquarium and works amazingly. It is completely silent and has very little consumption for its dynamics. It is the perfect solution.
Manual Aqua Medic DC Runner 3.3
Your question: Aqua Medic DC Runner 3.3
- Marcos A. wrote about Aqua Medic DC Runner 3.3 in 2022:
This a very good quality pump ,very quiet, with great performance, really happy about it
giorgos v. wrote about Aqua Medic DC Runner 3.3 in 2018:
ideal for sump filters. I use it in a 1000-liter aquarium and works amazingly. It is completely silent and has very little consumption for its dynamics. It is the perfect solution.
Show all reviews (3)
